description (300 watt) this 3 pin ultra low capacitance transient voltage suppressor is designed for use in applications where protection is required at the board level from voltage transients caused by electrostatic discharge (esd) as defined by iec 1000-4-2, electrical fast transients (eft) per iec 1000-4-4. this product provides unidirectional protection for 1 line by connecting the input/output line to pin 1, pin 2 to common or ground and pin 3 (is not connected). the SL03 thru sl24 product provides board level protection from static electricity and other induced-voltage surges that can damage sensitive circuitry. these transient voltage suppressor (tvs) diode arrays protect 3.0/3.3 volt components such as dram?s, sram?s, cmos, hcmos, hsic, and low voltage interfaces up to 24 volts. because of the physical size, weight and protection capabilities, this product is ideal for use in but not limited to miniaturized electronic equipment such as hand held instruments, computers, computer peripherals and cell phones. features protects 3.0/3.3 up through 24v components protects 1 unidirectional line provides electrically isolated protection sot-23 packaging maximum ratings operating temperatures: - 55 o c to +150 o c storage temperature: - 55 o c to +150 o c SL03 thru sl24 have a peak pulse power: 300 watts (8/20 msec, figure 1) pulse repetition rate: <.01% electrical characteristics @ 25 o c unless otherwise specified stand off voltage v wm volts breakdown voltage v br @1 ma volts clamping voltage v c @ 1 amp (figure 2) volts clamping voltage v c @ 5 amp (figure 2) volts leakage current i d @ v wm a capacitance @0v, 1 mhz c pf temperature coefficient of v br vbr mv/ oc part number device marking max min max max max max max SL03 l03 3.3 4 8 11 200 5 -5 sl05 l05 5.0 6.0 9.8 11 100 5 3 sl12 l12 12.0 13.3 19 26 1 5 10 sl15 l15 15.0 16.7 25 32 1 5 13 sl24 l24 24.0 26.7 44 57 1 5 30 note: transient voltage suppression (tvs) product is normally selected based on its stand off voltage v wm . product selected voltage should be equal to or greater than the continuous peak operating voltage of the circuit to be protected. packaging tape & reel eia standard 481 7 inch reel 5,000 pieces 13 inch reel 10,000 pieces mechanical molded sot-23 surface mount weight: .014 grams (approximate) body marked with device number SL03-sl24 tvs array series http://www.luguang.cn mail:lge@luguang.cn
wave forms mounting pad sot23 circuit diagram 0 10 20 30 0 50 100 t -- time in microsec ipp -- peak pulse current -- % ipp peak value -- ipp half-value -- ipp 2 8 x 20 waveform t t d package outline figure 2 pulse wave form figure 1 peak pulse power vs pulse time 100ns 1s 10s 100s 1ms 10ms t d ? pulse time - sec 100 10 1.0 .10 p pp - peak pulse power 8/20 s 300 w pulse SL03-sl24 tvs array series http://www.luguang.cn mail:lge@luguang.cn
|
